Wesba Clean
Spunlace vs meltblown vs woodpulp–PP
Quick answer
Choose spunlace for a cloth-like wipe and lower visible lint on many assembly jobs, meltblown PP for solvent wipe-down and oil pickup, and woodpulp–PP when the station needs a tough, high-hold shop towel. Confirm GSM, solvent, and surface on the quote — one family does not cover paint, cleanroom, and heavy grease.
Comparison table
Buyer decision table — not a lab certificate
| Question | Spunlace | Meltblown PP | Woodpulp–PP |
|---|---|---|---|
| Typical hand-feel | Softer, cloth-like | Finer, sometimes stiffer | Rag-like, bulky |
| Best first job | General wipe-down, some food-service lines | Degrease and light oil | Shop towels and oily soil |
| Lint risk | Depends on recipe — ask for the grade | Can shed under abrasion | Often higher than sealed cleanroom grades |
| Poor fit | Heavy scrubbing without an abrasive face | Delicate coatings if untested | Paint and electronics without a trial |
Quote the material that fits
Tell us industry, rough quantity, and destination. We reply with concrete options.
When each one wins
-
Spunlace
You need drape and a wipe people will actually pull from a dispenser all shift. Start with general industrial or kitchen lines, then test lint if the part is painted or assembled.
-
Meltblown
The job is solvent or oil film, not dust. Capillary PP picks up hydrocarbons better than a bulky woodpulp sheet in many drip jobs.
-
Woodpulp–PP
Technicians treat it like a rag: high liquid hold, repeated wipes, tools and housings. Quote it for the plant, not for the cleanroom.
When not to force one material
Do not put a woodpulp shop towel into a cleanroom SOP, and do not expect meltblown to feel like microfiber on glass. Abrasive faces scratch clearcoat. Oil-only pads are for spills; wipes are for surfaces.
What to send for a useful quote
- Surface (paint, metal, glass, food zone)
- Solvents from your SDS
- Lint sensitivity
- Roll or folded pack
- Destination country
